|
GPS PCB
Feb 17, 2019 10:42:21 GMT 2
Post by AlbEagle on Feb 17, 2019 10:42:21 GMT 2
What signal did you think of sending to the gps monitor? Thanks I hope I understood the question right. The display of the GPS is directly connected to an output of the graphics card. The buttons of the GPS are connected to the arduino.
|
|
aurel
New Member
Posts: 1
|
GPS PCB
Jan 27, 2022 20:09:23 GMT 2
Post by aurel on Jan 27, 2022 20:09:23 GMT 2
Hi, The whole C172 work is fantastic. I've taken the gerber files from the "Cessna172 Cockpit" and ordered them from Fusion PCB, but unfortunately I have quite an issue with the board GPS V1.1.The board I've received has holes (drills) too narrow to fit the 12 push button pins. I'm wondering if you've already have that feedback or did the board maker made a mistake ? I'm not an expert PCB designer, I only just can handle the basics from eagle. I would be happy though to make modifications, if they are needed on the components and the board if you have source files for Eagle (or just the schematic). I suppose I could also simply start from scratch but it would probably take me way more time than it would to someone decently skilled. So I guess my questions to you are: - Do you have Eagle files I could work with if the problem appears real
- Or do you have an updated Gerber zip file with bigger holes if the problem was real but has been fixed
- or do you think it's just a matter of asking the PCB maker to play closer attention to the READ-ME file ?
I've looked for 12mm Uxcell type buttons with narrower pins but they really all seem to have the same.
In any case, your Cessna 172 is awesome and I applaud your site too. It's a great help for simmers and great fun !
Thanks, Best regards, Aurelien (La Rochelle, LFBH, France) PS: I join a pic of the PCB with a close-up on the holes in questions, not sure it is obvious, but at least it may clarify what I'm talking about
|
|
|
GPS PCB
Jan 31, 2022 16:32:26 GMT 2
Post by AlbEagle on Jan 31, 2022 16:32:26 GMT 2
Hi there Aurelien, It is not neither your nor company's fault, the holes are a bit smaller, here is an updated file with bigger holes for tactile push buttons. GPS 5 Inch Janar 2022 - CADCAM.ZIP (113.83 KB)
|
|
|
GPS PCB
Jan 28, 2024 14:11:22 GMT 2
Post by biggles on Jan 28, 2024 14:11:22 GMT 2
Hi everybody, news for anyone interested in the GNS530 PCB. I have some available. If you're interested. The PCB is 6 euro and the shipping for Europe approximately 4 euro. Kind regards, Bart Hi Guys I'm looking to buy the PCB for the GPS Does anyone have a spare kicking around they want to sell ?
|
|