bux33
New Member
Posts: 4
|
Post by bux33 on Nov 12, 2022 18:19:39 GMT 2
Hi Alb, I saw that you also made the project for the 3d printing of the gps.
Will you share it with us?
A warm greeting |
|
|
|
Post by ido on Nov 9, 2023 19:29:10 GMT 2
any update about where to get the 3d file for the face plate?
and is there a difference in the face plate and functionality between the versions?
thanks
|
|
|
|
Post by AlbEagle on Nov 9, 2023 20:35:27 GMT 2
any update about where to get the 3d file for the face plate? and is there a difference in the face plate and functionality between the versions? thanks Hi, Which GPS version do you have? |
|
|
|
Post by ido on Nov 9, 2023 21:36:14 GMT 2
1.1
|
|
|
|
Post by AlbEagle on Nov 9, 2023 21:41:30 GMT 2
I will check and let you know |
|
|
|
Post by AlbEagle on Nov 9, 2023 23:15:14 GMT 2
|
|
|
|
Post by ido on Nov 10, 2023 1:32:08 GMT 2
thanks again
is this any different than the V2 face plate?
|
|
|
|
Post by AlbEagle on Nov 11, 2023 13:06:00 GMT 2
thanks again is this any different than the V2 face plate? V1.1 has DIY dual encoders, which don't have a push button, that's why I had to ad two extra push buttons on the sides of each rotary encoder. Also in V1.1 the tactile button holes are a bit smaller, which means you have to solder the buttons maybe from above because the pins might not fit through. V2 is the same but has bigger holes for the tactile buttons. V1 and V2   V2.2 is completely different because it has the EC11EBB24C03 dual encoders which have eliminated the 2 extra buttons. Also in the back of V2.2 you can attach an Arduino Mega 2560 pro. V2.2   |
|
