|
|
Post by Stefan on Jun 22, 2017 22:11:57 GMT 2
Hi. Great job!
Where did you found the white rectangle push buttons in your radio stack? You have listed red ones in your article. Did you paint them white?
|
|
|
|
Post by AlbEagle on Jun 24, 2017 20:54:49 GMT 2
Hi there Stefan, I have had the same problem finding white push button caps, so I had to buy them red and paint them. The Paint job is not great but i didn't have any other solution. If someone else has any source where can we find such white tactile push button caps, not only for frequency switching but for the radio channel switching, please share the source with us.
Regards AlbEagle
|
|
|
|
Post by richardschreier on May 17, 2021 21:56:45 GMT 2
Hi, I found your tactile buttons for 3d printing, awesome thanks! But I am curious how to attach the tactile button itself to the push button switch? The tactile button has a square hole and the push button switch a round top, do you think it is OK to just glue the tactile button to the switch? I thought it could be done easily by semi-assemblig the face plate over the PCB to make sure they tactile buttons line up with the switches properly... any suggestions? Thanks
|
|
