Post by polarair on Oct 23, 2020 15:41:06 GMT 2
I use the low pushbutton version in the clock, fit really nice.
About the bezels i need the cutout diagrams per bezel in 2D for a cnc or router table. I will get it to be done exernaly as i dont have the capabilities.
I found that the potentio meters and the encoders in use are not high enough, same with the switches for like DME. I need to think how to revise all on that side. I can cut a bit off the 7 seg displays so they end up lower. Ill tell you after the weekend.
As for the sim - Switch panel done - Trim and fuel control (Middle colom) done. Now its mnassive time needed to program airmanager on the radio. I think when done i will make a manual how to build this as there are many small details that where/are not on the web page.
But we can manage all....... L)
About the bezels i need the cutout diagrams per bezel in 2D for a cnc or router table. I will get it to be done exernaly as i dont have the capabilities.
I found that the potentio meters and the encoders in use are not high enough, same with the switches for like DME. I need to think how to revise all on that side. I can cut a bit off the 7 seg displays so they end up lower. Ill tell you after the weekend.
As for the sim - Switch panel done - Trim and fuel control (Middle colom) done. Now its mnassive time needed to program airmanager on the radio. I think when done i will make a manual how to build this as there are many small details that where/are not on the web page.
But we can manage all....... L)
