kklee6
Junior Member
Posts: 87
|
Post by kklee6 on Nov 22, 2020 10:50:42 GMT 2
Hi AlbEagle, Sorry to bother you again. I am starting to work on the Mobiflight codes for the PCB version. I have a question about the DME and transponder 7-segment display modules. Should they programme as ONE 8-digit module or TWO separate 4-digit modules?  Many thanks. KK |
|
|
|
Post by AlbEagle on Nov 22, 2020 12:00:27 GMT 2
Hi AlbEagle, Sorry to bother you again. I am starting to work on the Mobiflight codes for the PCB version. I have a question about the DME and transponder 7-segment display modules. Should they programme as ONE 8-digit module or TWO separate 4-digit modules? View AttachmentMany thanks. KK Hi there KK 8 for the ADF and 8 for the Transponder. There are 8 digits connected to one max chip. If there are 8 digits connected to one chip than you have to program them as one 8 digit module.  for Dme, there are 3 chips, one for the numbers (8 digits), one for NM Letters and one for KT Letters.  |
|
|
|
Post by AlbEagle on Nov 22, 2020 12:08:56 GMT 2
For DME you need to program two for the numbers and two for the NM and KT letters, but later you will double these if you want to be able to turn them on and off, which means one with data displayed and one with spaces so there is blank values if you turn the instruments off.
|
|
|
|
Post by AlbEagle on Nov 22, 2020 12:12:58 GMT 2
See the picture below, and also find attached the config file, you might need to experiment with it. If it doesn't work, turn all the options off and start activating them one by one and test them.  DisplaysAugust2020.mfmc (1.69 KB) |
|
