Post by kklee6 on Dec 13, 2020 8:38:31 GMT 2
HI,
I have almost completed this PCB radio stack project. The next step is 3D printing the buttons and laser cutting the faceplate.
In Mobilfight, I set up two configuration, one ON state and one OFF state, for each display.
Most of them works fine but there is a minor problem with the Alphanumeric displays.
The ON state is fine but, for OFF state, I write 4 blanks to the display and it looks like this:
So, my question is what I should write to displays to blank them completely.
Thanks.
KK
I have almost completed this PCB radio stack project. The next step is 3D printing the buttons and laser cutting the faceplate.
In Mobilfight, I set up two configuration, one ON state and one OFF state, for each display.
Most of them works fine but there is a minor problem with the Alphanumeric displays.
The ON state is fine but, for OFF state, I write 4 blanks to the display and it looks like this:
So, my question is what I should write to displays to blank them completely.
Thanks.
KK